Home > News > Content

General Standards And Common Problems Of Anti-corrosion Resin Engineering Construction

Jun 09, 2020

Article Summary: Environmental Standards: Construction work is prohibited on strong wind days; construction work should not be carried out on wet and cold surfaces, the surface temperature of anti-corrosion resin construction should not be less than 3℃, and the air humidity should not exceed 85; the average temperature When the temperature is less than 5℃, the drying rate slows down obviously, and generally no immediate work is carried out.

Environmental standards: Construction work is prohibited on strong wind days; construction work should not be carried out on wet and cold surfaces; the surface temperature of anti-corrosion resin construction should not be less than 3℃, the air humidity should not exceed 85; the average temperature should be less than 5℃ At this time, the drying rate slows down significantly and generally no immediate work is carried out.


  Winter construction measures: In order to ensure the dry solidification of winter construction measures, the outside of the lining machinery and equipment and the exhaust duct should be covered with thermal insulation materials. Using gas heating equipment, according to the heat convection of the gas, the surface of the lined sheet is heated to about 10 ℃, and steam pipes can also be used to heat the equipment. Ambient humidity manipulation: The air humidity inside the machine can generally not exceed 80.


  Notice: The engineering construction supplies should be cleaned, and should be cleaned and tidy after each project construction, so that it can be reused when the time comes. The construction site needs to have machinery and equipment that are waterproof, rainproof, small dewdrops and floating dust. Resolutely prevent water and dirt from falling into it, so as not to harm the quality of the coating. There should be universal standards during the construction of the project. All fires should be dissuaded, and the bottom pressure switching power supply should be used for the lighting fixtures.

Source:http://www.up-resin.com/

Back