Home > News > Content

Mixed Application Of Anti-corrosion Resin And Hardener

Jun 09, 2020

Article Summary: Preservative resin and hardener are packaged in two separate containers with the correct predetermined mixing weight ratio. Add all the hardener to the anti-corrosion resin. The two components should be mixed using a low-speed mixer (300 rpm) for about 5 minutes. It is important to thoroughly stir the mixture near the sides and bottom of the container to evenly disperse the curing agent.

   The substrate must be dry, stable, and free of anything that would hinder adhesion, such as dust, loose particles, grease, rust, or any kind of corrosion. According to the nature of the substrate, it should be pre-repaired by brushing, rubbing, sandblasting, etc., and then completely remove the dust.


   Preservative resin and hardener are packaged in two separate containers with the correct predetermined mixing weight ratio. Add all the hardener to the anti-corrosion resin. The two components should be mixed using a low-speed mixer (300 rpm) for about 5 minutes. It is important to thoroughly stir the mixture near the sides and bottom of the container to evenly disperse the curing agent.


   To apply primer, please spray 2 layers with a brush, roller or spray gun. Once the first layer is dry, the second layer can be used, but within 24 hours; consumption: 150-200g/m2 per layer.


   Subsequently, within the next 24 hours, after the primer is completely dried, the application of the selected system can be carried out. If you choose to use it as a finish, you should apply 2 additional layers. After the first layer is completely dried, the second layer is applied within 24 hours.

Source:http://www.up-resin.com/

Back