Home > News > Content

Problems And Solutions In Resin White Embryo Processing And Production (3)

Jun 24, 2020

Industry news: Common problems in the production of resin white embryos are the production of stone powder after caustic soda, and the product foam is not completely shiny.

In the production process of the handicraft factory, when the product is soaked in alkali, there is powder in the texture; this affects the quality of the product. This problem is particularly likely to occur in autumn and winter and winter. The reason for its formation is that the resin on the surface of the product is not completely cured, and the alkali time is too long, which will corrode the resin on the surface of the product, and eventually leave the stone powder on the surface of the product. The methods to solve this problem are as follows:

1. Strictly control the minimum dosage of curing agent. When the surface of the product is seriously sticking to the hands, it should be checked whether the amount of curing agent is sufficient. If it is not enough, the amount of curing agent should be increased. The amount of curing agent is generally 1.5-2.5%. When the amount of curing agent is increased, the resin gel is too fast, and it is too late to operate. Slow-drying resin should be adjusted to incorporate or add slow-drying agent. When the amount of curing agent is increased, the resin is still drying slowly and the surface is sticky. Check if there is a problem with the curing agent, or if there is a problem with the filler and accelerator. In the cold winter, the resin gel is slow, which can increase the ambient temperature or make the curing area, or the slurry water bath can be heated.

2. Standardize the concentration of lye and the time of caustic soda. Good products can also be immersed for a long time in high-concentration alkaline solution. The pH value of common alkaline solution should be controlled between 11-12, and the time of caustic soda should be strictly controlled as required.

3. Do not use low-concentration resin as much as possible, because the thinner resin has lower solid content, and the acid and alkali resistance after curing is poor. When soaked in alkali, it is easy to corrode the resin on the surface of the product.

4. If the foam is not completely soaked, don't soak it again. You can also use a cloth dipped in acetone to clean the area where it is not soaked.

Neweo Chemical specializes in high-quality chemical accessories such as unsaturated resins for crafts, vinyl resins, epoxy resins and curing agents, accelerators, fiberglass cloths. The resins sold by our company are green and environmentally friendly products with superior performance and low price. We will continue to produce more high-quality products to meet the needs of economic and social development, keep up with the pace of the times, and provide you with inexpensive resins. Welcome to call for consultation.

Source:https://www.up-resin.com/

Back